Concern about placement of waste tube....

[katienoellewis]

We have a new Axxess Toyhauler Polaris edition that we are getting ready to take out for the first time this weekend.  Upon looking over everything, we're a little concerned about the placement of the waste tube.....  It is really low to the ground.  It seems like it would be hit by any bump/rock we may encounter.  Is this the way it looks on all Livin' Lite products?  Is this normal for a toyhauler?


[attachment id="37" thumbnail="1"]

[stewartnp]

Looks about the same on my 13QBB

[davidb]

I was also disappointed with how low my drain fittings were, I loosened all the clamps thinking I could move the pipes up an inch or two, but they wouldn't budge.

I installed some lift kits from Perfect Casita that raised the body an additional 3 inches on my 6x15 vrv toyhauler.

They consist of rectangular tubes (powder coated) along with bolt assys. You simply unbolt the axles, then reinstall the axle with the blocks.

I had to extend the brake wires slightly.

[attachment id="226" thumbnail="1"]before lift kit install, water tank is lower than axle.          [attachment id="229" thumbnail="1"]  all parts were included, including nuts with tabs welded to keep them
                                                                                                                                                                                   from spinning when tightening them.