Archive - Aluminium Camper Forum

Thanks for the tip on the install. I think David may be right. I need that socket.
Yes  I read on line what that rod is about . Keeps the tank alive longer stopping the corrosion build up.

My old camper had one too but , it had a drain valve installed on the plug itself. I may look for one like that and install it instead.

I just need to figure out the size first.

I'm looking at this one for a replacement.  [a href="https://www.amazon.com/NW-Leisure-TSA200-Saver-Anode/dp/B000HYOUSC/ref=pd_sbs_263_4?_encoding=UTF8&psc=1&refRID=V9HW1G4YX1YDKY2SVD5Q"]link[/a]

Again thanks for the replies.

I am a little surprised that you got the plug off without a socket wrench, but that is the way to get it back in. The rod is an aluminum or magnesium anode that protects the water heater from corrosion. If it is more than 1/3 corroded, replace it.

David

[font size="3"]I suppose it is possible that this forum URL will continue to work but Thor/LL will administer it. Content would be under their control so only time will tell what happens. Maybe I will get to 2K posts although that's a dubious goal  
[/font]

Perhaps Thor will have a change of heart. Then I can say that I am Thor too!

Quote from: @jimt" timestamp="1483245658" source="/post/26745/threadUpdate on my issue.

I did get the cover off using my brand new standard number 2 Robertson head. I must say that only 2 screws held things in place. 2 of them were so short they didn't even make it through the cover frame.

I did have a built in hot water by pass already installed so things got very easy after that.

My only issue now is the hot water tank plug. I was able to unscrew  the plug and let the hot water tank drain just fine.
HA now I have a new issue. How in the world does one get that plug back in. The plug has this long rod on it. Not sure why that is.

I did not harm the threads I have checked. Yet I can not get that plug to start threading back in. Very limited space for my hand to even try and start it back.

Any hints or tips would be nice. I have no idea what the actual socket size is and maybe using a socket to thread it back would be the easy way. I just hate to think I have to buy a large special socket just for that.

Thanks for any help in advance.

Yeah, it can be a challenge.  Try putting firm pressure and a little extra pressure at the bottom as you start to turn in/install.  

The end...

HNY!  Still here?  Last?

Stick a fork in it?

Update on my issue.

I did get the cover off using my brand new standard number 2 Robertson head. I must say that only 2 screws held things in place. 2 of them were so short they didn't even make it through the cover frame.

I did have a built in hot water by pass already installed so things got very easy after that.

My only issue now is the hot water tank plug. I was able to unscrew  the plug and let the hot water tank drain just fine.
HA now I have a new issue. How in the world does one get that plug back in. The plug has this long rod on it. Not sure why that is.

I did not harm the threads I have checked. Yet I can not get that plug to start threading back in. Very limited space for my hand to even try and start it back.

Any hints or tips would be nice. I have no idea what the actual socket size is and maybe using a socket to thread it back would be the easy way. I just hate to think I have to buy a large special socket just for that.

Thanks for any help in advance.